Mazda 3 Gearshift Sticking
More items in the Facebook group page at www.facebook.com/groups/mazaclubusa
Please note: Questions and answers are provided for information and advice purposes. No liability either express or implied is assumed by reliance on the information presented either by the writers or the MC.
Some or all of the below is from our Facebook group page and this is just a part of what appears there and in the member magazine.
Also be sure to see our Facebook group page for immediate help from fellow members.
Q: I recently purchased a used 2008 Mazda 3 (manual transmission) with about 120,00 miles on it. Sometimes, when I attempt to shift from 2nd to 3rd, the gearshift sticks, and Iím unable to shift into 3rd. I have to pull over and repeatedly jiggle the gearshift to pop it out of second gear. Also, when stopped, Iíve sometimes had trouble putting the car into 1st. And, overall, shifting from 1st to 2nd is a little rough. The brake/clutch fluid is topped off, so itís not that. And the clutch itself seems fine. Any ideas ?
A new clutch. While the clutch material may well still have some life in it, the two halves of the disk have started to separate and they are still partially engaged even when you push the pedal all of the way to the floor.
A Clutch Master Cylinder and/or Clutch Slave Cylinder starting to fail. In this scenario, even when you push the pedal all of the way to the floor, the clutch pressure plate doesnít fully release, and as with Option 1, the clutch disk is still partially engaged.
Low hydraulic fluid in the Clutch Master Cylinder. It could be you are pumping (or have pumped) some air into the hydraulic clutch line, and the air is compressing instead of pushing on the pressure plate to open it up all of the way. The clutch disk is still partially engaged.